can you confirm these are the frame hangers?
http://diy4x.com/cart/index.php?route=product/product&path=24&product_id=114
http://diy4x.com/cart/index.php?route=product/product&path=24&product_id=114
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
ORD(u bolt kit) and GM(engine cross member)
- Thread starter Babaganoosh
- Start date
Yes, those are them.
PM'd
chevysmithz71
1/2 ton status
Brake lines still available?
Yes they are
chevysmithz71
1/2 ton status
cool. I see will fit 81 up but what length or lift are they for?
Stephen recommended them with my 4 inch lift 12 inch travel springs. I don't remember then length or part number off them I will have to measure them.
chevysmithz71
1/2 ton status
ok. some measurements would help out. thanks
all 3 right?
all 3 right?
Sure, I'll see what I can do. I have to remember where they are. 
Give me about 30 minutes and I should have it. They must be in the truck about 10 mins away, I can't seem to find them here with me.
Yes all 3 or the front's if you want.
Give me about 30 minutes and I should have it. They must be in the truck about 10 mins away, I can't seem to find them here with me.Yes all 3 or the front's if you want.
Last edited:
I'll be headed over to the garage some point today, I'll take a look around for you and take them home.
Sorry it took so long, I couldn't find them to save my life.
GU30011
VEHICLE KIT (‘73-‘78.5 -- 4-6” lift) (2 fronts, 1 rear) $112.00
OLD #7215 FRONTS: 25” long, 3/16”IF @ frame, 7/16” banjo
REAR: 18” long, ¼”IF @ frame, 3/16” T-outs
chevysmithz71
1/2 ton status
Thanks for getting the measurements to me. I'm a little unsure of something. Your original post says 81+, your build is an 82 but the brake line kit is for 70's? I figure you're using a 70s axle?
Ill have to give mine a check. Is it just the head size of 10mm or 7/16 they refer to or is there a thread difference?
That doesn't seem right they should be for a 91 axle.
chevysmithz71
1/2 ton status
I also noticed the Numbers don't really match up to ORDs site.
the 3001 is for 79-98 but then the "old7215"?? is 73-78. I am interested in getting those so this isn't just for zhits and giggles. Just trying to figure it out.
Thanks
the 3001 is for 79-98 but then the "old7215"?? is 73-78. I am interested in getting those so this isn't just for zhits and giggles. Just trying to figure it out.
Thanks
I went off the label on the package, I'm not sure. When I get home I will take a better look and try to solve this.
Ok It seems like ORD has the same part numbers for the different style fitting, these should be the 10mm banjo fitting.
Sorry for the confusion.
Sorry for the confusion.
do you still have the cross member ? is it trans crossmemeber and what year im looking for a 1980 -84 4 wheel
It's a factory 4wd engine cross member not cracked.
ok i was looking for a trans crossmember
