I figure it should get better mileage as it gets lighter.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
It's called a pun. Look it up.
yes, my comment was a pun. I'm glad you were able to recognize that
Mine was the pun. Yours was redundant.
Haha! Last few comments.
Grumpy old men! Except Mark isn’t that old. Lol!
Grumpy old men! Except Mark isn’t that old. Lol!
He is practicing, so he will be ready.
And Wade plays the role of mean older brother
Get off my lawn.
I have headlights. LED even.
Nice segue to get back on topic. How’s the wiring?
The 5 on the back of the cab are in but not wired. Front 5 on the cab still need swapped. Front running/turn need to be installed and wired. Then the lights are done. All 20 of them.
Nothing yet. Good thing is, the fuel level sending unit seems to work when I tested it. So I don't have to cut access in the bed.
Fixed it for ya.
All of the lights are officially done. The only electrical left is the transmission controls and gauges.
Now on to the transmission.
Now on to the transmission.
New plate showed up.
Did a decibels check for before. Sound deadening is being ordered. 84.5 was the max.
Did a decibels check for before. Sound deadening is being ordered. 84.5 was the max.
My brain no not works so good no more.
I built the wing cross mounts on the wing.
Laid the whole thing out in CAD. Cut the rear down bars which taper outta 15*. Had to hand chamfer them because my 1" hole saw will not mount on my notcher. Cut the base end at 15*. These stand up verticle front to back. Laid them out on the welding bench. Something did not look right. Looked to short.
Yep. I cut the lengths based on the front hight. 10" too short. Because the fronts are angled 2 directions, these are to short for that use.
Headed to the education pile.
I built the wing cross mounts on the wing.
Laid the whole thing out in CAD. Cut the rear down bars which taper outta 15*. Had to hand chamfer them because my 1" hole saw will not mount on my notcher. Cut the base end at 15*. These stand up verticle front to back. Laid them out on the welding bench. Something did not look right. Looked to short.
Yep. I cut the lengths based on the front hight. 10" too short. Because the fronts are angled 2 directions, these are to short for that use.
Headed to the education pile.
