T
tenderfoot
Guest
Does this make you, Eddy?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
77K5. The IronMaiden...9/2 headed for Blazer Bash 20!
- Thread starter 76zimmer
- Start date
-
- Tags
- 14bff bearing desintigrated 454 cookies custom diy4x aluminum fuel tank diy4x flatback dif covers diy4x frame boxing kit diy4x wraptor/truss ez-efi fords suck hemi orange and school bus yellow index l&l headers long/dana coolers making me her bitch. more tranny problems one tons phoenix trans convertor th400 full manual
jack of all trades build, overland, dunes, rocks, trails
T
tenderfoot
Guest
Ahhh
Filter and pan installed w lube locker gasket...love those things!
Doubler Shifters hooked up
Still need to replace the trans shifter cable
Still need to fill the doubler w gearlube
Cooler installed and new lines ran to the cooler via different routing.
Old lines ran under the core support, these runs up and out of the way.
Doubler Shifters hooked up
Still need to replace the trans shifter cable
Still need to fill the doubler w gearlube
Cooler installed and new lines ran to the cooler via different routing.
Old lines ran under the core support, these runs up and out of the way.
Last edited:
Finished the new transmission lines, but still need to make some new mounting points to secure them to.
Pulled the diff covers... my granddaughter helped me for a couple hours.
All good with the D60, not so much on the 14BFF ... found a few chips of metal...further investigation required....any guesses?
Pulled the diff covers... my granddaughter helped me for a couple hours.
All good with the D60, not so much on the 14BFF ... found a few chips of metal...further investigation required....any guesses?
pic whore damit!!
Pinion bearing(s)? There is also the 3rd bearing which I think they call a straddle bearing.
lol...what did I do to deserve that?
you wants pics....sure here ya go:
see that metal ring in front of the ring gear?
for you Mark...
Just ball bustin!
here’s what I see, the circled area looks to be different than the section going clockwise
Where was that floating at? That almost looks like Detroit internals. Might oughta send that pic to Eric...
wasted wages
1 ton status
I can see pieces of schrapnel up by the pilot bearing...I would pull the pinion housing...
Don’t know what was in there that wants out? But I do remember you saying...
Not once do I regret putting a BB in this thing!
Not once do I regret putting a BB in this thing!
wasted wages
1 ton status
Something may have tried to run between the pinion and ring gear teeth and caused the bearing to grenade.... it may not be too bad at this point....
Pulling the pinion housing and taking a look is going to make the difference.
May be able to change out the bearing and clean the chips out..refill it and run it..
Pulling the pinion housing and taking a look is going to make the difference.
May be able to change out the bearing and clean the chips out..refill it and run it..
It looks like the rollers are missing. Usually you can see the end of all of them. I'd make sure to check down your tubes and everything so you don't get a surprise later. My Bee ate that bearing and chewed the chit out of the gears.
