CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Not now. Probably at some point.
They don't have much right now. All junk.
They don't have much right now. All junk.
Are they 52" springs? They look offset.
Martin
Martin
Going to do a 1" body lift while you have it apart?
Martin
Martin
I guess I'm not sure. I thought all rear 1/2 ton springs were 52's?
I don't know, I might do a body lift. We'll see. Trying to save money.
I don't know, I might do a body lift. We'll see. Trying to save money.
I understand stand that.
Measure the springs, that will tell you.
People have ran 56" springs up front too.
Martin
Measure the springs, that will tell you.
People have ran 56" springs up front too.
Martin
They're 56's. Dammit. Maybe I should just put these on the rear.
A 1" body lift is relatively cheap, and all new hardware is nice.
http://www.offroaddesign.com/catalog/oneinchlift.htm
Martin
http://www.offroaddesign.com/catalog/oneinchlift.htm
Martin
I thought they looked offset.
You could probably run them on the front, with the long side back, and then not have to mdo be your FUSH's?
Martin
Screw it, just run 63's up front.
That's the way my 52's are setup. Kinda screws with your caster angle so you'll need some shims.
Got a little more done today. Don't laugh at my welds. It's been 3 years since I was welding regularly.
Not in the near future.
Yeah I know. I thought about and decided not to do it right now.
There's not a ton of frame to take off with the K5 tank back there anyway.
I like it. Now finish it.
