Only downside of putting the ECU in the cab is the hole for the cable end.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Edelbrock Proflo 4
- Thread starter 6872xtc
- Start date
Yes, that's probably my biggest reluctance to doing it.
mine is under the hood now 1.5 years no problems rain / snow / dry / wet / hot / cold .
I don’t like the way it looks under the hood more than anything else.
Kain
3/4 ton status
can a dead battery kill an o2 sensor?
Kain
3/4 ton status
two batterys died when it got cold and the bran new o2 sensor i just put in the system tells me its bad
Where did you all mount your coils? Tried searching and didn't find many examples. Been a long time since I needed to mount a coil.
I bought a bracket so I can firewall mount it like my other K10.
X2 on mine .
Kain
3/4 ton status
one of these and just mounted to the firewall
https://www.oreillyauto.com/detail/...t-ignition-coil-mounting-bracket/6055/4514268
https://www.oreillyauto.com/detail/...t-ignition-coil-mounting-bracket/6055/4514268
Same here. Used this one. There are some nice billet ones that are cheaper but won't work since the firewall is not flat in the area close to the distributor
the coil I ended up using MSD Part # 8223. This one makes it easier for the coil wire. I tried a very short 4" wire but that did not turn out well and is way too short. Ended with a longer one that does half circle around distributor to the coil.
the coil I ended up using MSD Part # 8223. This one makes it easier for the coil wire. I tried a very short 4" wire but that did not turn out well and is way too short. Ended with a longer one that does half circle around distributor to the coil.
Last edited:
that’s a fancy clamp, I like it.
I went with a cheaper summit clamp in black that matches my black coil.
I like the one bolt hole option. And cheaper.
