Don't sweat it, it's super easy. I was nervous about mine as well, but once I dived in, it was pretty simple. Basically just clean up the axles real good where the perches are going to be, then bolt it all together (not too tight) without welding it. Then you are free to swing the pinion up and down as needed to get the right angle. Once that is set, tack weld the perches, then take it all apart and finish welding. Shock mounts are pretty much the same... bolt it together, check it, then tack and take it apart for final welding.Where I'm nervous is setting the spring perches. And shock mounts. Axle swaps are way easy but I've never had to mess with those before.
If I can, I'll stop by Saturday, probably with Eric.
@blazinzuk


