CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
@skunked @mrk5

Recommendations on a distributor that is compatible with timimg control?


Wow, pricier than I expected, but I guess that my wife already hates me, so add a coil and wires, and she'll have plenty to be upset about...

Any particular coil?
If you're going to make her unhappy, no point in holding back: https://www.summitracing.com/parts/...ATM9knMkSU56WUvSj4gkNfSrFBdEqegRoCDLwQAvD_BwE
 
Personally I like the Blaster SS coils. https://www.msdperformance.com/prod...Ju8eXIGbMH7f38cwFtzV0fWXltd9Xd0BoCrC8QAvD_BwE

8207_v1.jpg
 
I don't know how much better it is for general use, especially throttle body type injection. I used the Holley dual sync because it was an easy setup and plugged right into the Sniper harness.

I do know a few people have had trouble with RF interference which won't happen with the dual sync. However, I didn't have RF trouble with the MSD.

The only thing I read that you can do with dual sync and not magnetic is setting a different timing for engine cranking. Which I use because I like a lot of initial advance.
 
Yeah, some guy named Greg sent me a heavy box...






Finally:D
 
He lives in Kansas...... He got lost trying to get them shipped, because he didn't have any mountains to give him direction reference.....

:haha:
They have that one big flat top hill with the windmills on it. Not sure how far away it can be seen from though.
 
Mound o flower at ~4000’ is the highest point in Kansas.

The lowest point in Colorado is 3300’

That’s just crazy to ponder
 
Any updates?
Really nothing.

I haven't had the time to mess with much.

I was feeling really depressed with how far gone my work area had been getting. I live in a never ending cycle of too much to do, and not enough time to accomplish it. This usually requires trying to scramble to fix something, knowing ahead of time that I don't really have the time I need to begin with, and inevitably results in a pile of tools and empty parts boxes that "I'll clean up later". Several occasions of this cycle later, and I couldn't even walk through the garage.

So I decided to try and do some things to help. I moved the garage around, my toolbox is in a new spot, allowing for more permanent shelving to be built, and I moved the garage fridge over right next to the door, so wifey can get in and out of it without having to navigate any other future garage disasters.

I also acquired a 30 drawer storage bin that I still need to utilize. Having buckets of bolts and clamps and other small items is getting old. Hoping to be able to have a place for everything when I'm done. A bunch of things will be offered for the "cost of the ride" and/or thrown away.

Then I will be have to spend time making the green one run decent, it'll get transferred to daily status so my actual daily can go under the knife...
 

Latest Posts

Top Bottom