The Bent77 K10 now tow pig

[Bent77]

Oh wait, it's my thread.

Pulling the IAC

 

[skunked]

I fk'n HATE spiders

 

[Bent77]

Depends on the flavor, but they're better than snakes

 

[Bent77]

Cleaned a bunch of junk out of the IAC, replaced all of the vacuum plugs and a new PCV. Acts more appropriate, but will be checking it.

Unloaded the HP into the garage and got it up in stands to start the disassembly

 

[mrk5]

At least spiders have a visible means of moving about. Snakes move unnaturally. Something just not right there....

 

[Bent77]

So, couple minor things.

Dropping RPM still on deceleration, tries to die before catching itself. Put a volt meter on the TPS, running .555VDC at closed throttle position, 3.5 VDC WOT. If you drop the butterflies shut, it drops to ~.4 VDC before returning to .55. Think i have a bad TPS. Adjusted the idle screw just enough to move it off that spot, and will drive out tomorrow.

Sounds like my Steinway™ sliders have shipped. Guess I'll beat the rockers back out!

 

[Bent77]

Straightened the drivers side rocker today

 

[Bent77]

Managed to get the front fender halfway decent again.
Major cancer surgery is needed underneath

 

[Justin V]

View attachment 204169
Straightened the drivers side rocker today

Sweet hammer.

 

[Bent77]

That's my rust remover man!

 

[Justin V]

That's my rust remover man!

I may need to borrow that.

 

[JoshHefnerX]

Rust is no Bueno..

 

[Justin V]

I kinda like it. Adds character.

 

[tRustyK5]

View attachment 204184
Managed to get the front fender halfway decent again.
Major cancer surgery is needed underneath

On the upside, your door gaps looks wonderful!

 

[benchseat4speed]

I have a '77 too. I know that hammer, and the 5# pile of rust flakes and dirt next to it.

 

[Bent77]

My Steinway slider kit came in

 

[Bent77]

@6872xtc
Look how pretty...

Bite me


@Stein
You should sell these. Worth at least 2 cases of beer

 

[Bent77]

.120" x .750" runners

 

[Bent77]

Stein's cuts were perfect. Just had to back bow them a tad to get them flat for this fit.

@&#€ing excellent fit.
Thanks John

 

[Babaganoosh]

Take more pics, im interested in how your getting it done and how well it will work.

No one loves a reg cab long bed so we need to stick together!